Network - Graco SaniForce SDU Series Manual

Electro-pneumatic Control Panel Display Screens

Network

Network Network
To reduce the risk of injury due to electric
shock, remove power to the control panel before
entering the control panel to make connections for
measurement devices.
The Network page is used to configure the SDU for
network communication.
Currently, the system is only configured to
communicate through Ethernet/IP (EIP) protocol to a
remote programmable logic controller (PLC). Contact
Graco Customer Support for information regarding
network communication protocols.
Icon/Field Icon/Field Icon/Field Description Description Description
DHCP DHCP DHCP Check to enable Dynamic Host Configuration Protocol for the network connection.
IP IP IP Address Address
Address The current IP Address of the system is displayed here. If DHCP is disabled, these fields
become editable to enter a static IP address.
Subnet Mask Mask
Subnet Subnet Mask The current Subnet Mask utilized by the system is displayed here. If DHCP is disabled,
these fields become editable to enter a Subnet Mask.
Enable Enable Enable Check to enable EIP network communication.
Ethernet/IP
Ethernet/IP Ethernet/IP
Remote IP IP IP Remote Remote Enter the IP Address of the remote PLC for the system to talk to.
Address Address Address
Save
Save Save
The Save button will be active if the IP Address, Subnet Mask, or the Remote IP Address
have been edited. Press the Save button to save the edited value before leaving the Network
screen. Changes may be lost if the Save button is not pressed. If network communication
is enabled, restart the system to resume network communication after saving a value
in the Network settings.
Override
Override Override Check to stop reading values driven by the remote PLC into the system. If a sequence is
Remote Remote Remote running, select the Override Remote box to stop the sequence and put the system in standby.
Ethernet/IP Ethernet/IP Ethernet/IP Shows if the active communication is connected or disconnected from the remote PLC.
Status
Status Status
52 3A5402J