Hearth and Home Technologies IntelliFire App Installation Instructions & User Manual page 22

Other
This screen allows the operation of paired accessories
such as a fan or light and the Cold Climate mode. See
Figure 5.
This appliance defaults to the previous settings, when the
flame is turned back on.
BRAND NAME
Figure 5 Functions
Cold Climate
This function turns on a small pilot flame and keeps the air
inside your appliance warm while not in use. It is a useful
feature in colder weather to minimize condensation on
the appliance glass. See Figure 5.
Note: This feature is not available if a Power Vent or
Smart Wall is installed on the appliance.
Note: The continuous pilot will automatically turn OFF
after 166 hours if appliance is not actively used. If Flame
ON is activated before 166 hours, the automatic timer will
reset.
Hearth & Home Technologies • IntelliFire App Installation Instructions & User Guide • 2326-985 • 7/20
FUNCTIONS - ANDROID FUNCTIONS - ANDROID
LIGHTS
ADJUSTMENT
FAN SPEED
ADJUSTMENT
COLD CLIMATE
ON/OFF TOGGLE
SWITCH
Lights
The lights will only appear if that feature is available on
your appliance. Adjust the lights in the appliance using
the slider bar on app screen.
See Figure 5.
Fan
The fan will only appear if the feature is available on
your appliance. Your appliance has a built-in delay
that prevents the fan from operating within the first 3
minutes of operation. This allows the air to be heated to
a comfortable temperature before the fan circulates it.
Adjust the fan speed using the slider bar on app screen.
There are 4 levels for fan speed. See Figure 5.
· The fan will always start on Level 4 for the first ten
seconds, then automatically adjust to the speed
selected on the app.
· The fan will automatically run for 12 minutes after the
flame is turned OFF. This feature is intended to transfer
residual heat from the appliance.
Power Vent
If the appliance was installed with a Power Vent, a two
minute pre-purge is required between the ON command
and the flame ignition. The app will display a pop-up
message to confirm that Power Vent is in pre-purge mode.
There are 3 light levels.
22