Hearth and Home Technologies IntelliFire App Installation Instructions & User Manual page 11

Other
This screen allows the operation of paired accessories
such as a fan or light and activate the Cold Climate mode.
See Figure 5.
This appliance defaults to the previous settings, when
activated.
Figure 5 Functions
Cold Climate
This function turns on a small continuous pilot flame and
keeps the air inside your appliance warm while not in use.
It is a useful feature in colder weather to minimize con-
densation on the appliance glass.
Note: This feature is not available if a Power Vent or
Smart Wall is installed on the appliance.
Note: The Cold Climate function will automatically turn
OFF after 166 hours if appliance is not actively used. If
Flame ON is activated before 166 hours, the cold climate
timer will reset.
Lights
The lights will only appear if that feature is available on
your appliance. Adjust the lights in the appliance using
the slider bar on app screen. There are three light levels.
11 Hearth & Home Technologies • IntelliFire App Installation Instructions & User Guide • 2326-985 • 7/20
FUNCTIONS - iOS FUNCTIONS - iOS
LIGHTS
ADJUSTMENT
FAN SPEED
ADJUSTMENT
COLD CLIMATE
ON/OFF TOGGLE
SWITCH
Fan
The fan will only appear if the feature is available on
your appliance. Your appliance has a built-in delay that
prevents the fan from operating within the first three
minutes of operation. This allows the air to be heated to
a comfortable temperature before the fan circulates it.
Adjust the fan speed using the slider bar on app screen.
There are four levels for fan speed.
· The fan will always start on Level 4 for the first ten
seconds, then automatically adjust to the speed
selected on the app.
· The fan will automatically run for 12 minutes after the
flame is turned OFF. This feature is intended to transfer
residual heat from the appliance.
Power Vent
If the appliance was installed with a Power Vent, a two
minute pre-purge is required between the ON command
and the flame ignition. The app may display a pop-up
message to confirm that Power Vent is in pre-purge mode.