Getting Started - Wasp WPA1200 Product Reference Manual

Getting Started

This section explains how to install and charge the battery, how to check battery status, how to turn on the
WPA1200, and how to calibrate the screen.
Installing the Battery
Warning: There is a risk of fire and burns if the battery pack is handled improperly. DO NOT disassemble, crush,
puncture, short external contacts, or dispose of the battery pack in fire or water. DO NOT attempt to open or
service the battery pack. Dispose of used batteries according to local recycling guidelines in your area.
A backup battery cell is embedded into your device to prevent data loss in instances when the removable battery
pack is removed or completely discharged. This backup battery cell will only support the system for a maximum of
2 hours.
Note: To enable the internal battery cell to provide backup power supply, charge your device with the main
battery pack for at least 16 hours.
1. Open the battery compartment by pushing the latch in the direction of the arrow and lift up.
The battery compartment is displayed below:
Note: The plastic battery tab makes it easy to remove the battery.
2. Locate the backup battery switch and turn it on.
Backup Battery Switch
WPA1200 Product Reference Guide
Compartment Contacts
Plastic Battery Tabs
Battery Securing Clip
5