Led Display - Dimplex DCP9 Instruction Manual

Functions

LED DISPLAY

The LED display shows the set temperature while on COOL or AUTO MODE. While in
DRY and FAN MODE, it shows the ambient room temperature.
ERROR CODES
E0 - PCB error, contact the manufacturer.
E1 - Room temperature sensor error.
E2 - Evaporator temperature sensor error.
E3 - Condenser temperature sensor error (on some models).
E4 - Display panel communication error.
EC - Refrigerant leakage detection malfunction(on some models).
Protection code:
P1 - Bottom tray is full - Connect the drain hose and drain the collected water
away. If protection repeats, call for techinical assistance.
NOTE: When one of the above malfunctions occurs, turn the unit OFF, and check
for any obstructions. Restart the unit, if the malfunction is still present, turn OFF the
unit and unplug the power cord. Contact the manufacturer or its service agents or a
similar qualified person for service.
SLEEP/ECO MODE
This feature can only be activated by the remote control. To activate SLEEP mode,
press the SLEEP button on the remote control. The set temperature will increase
(cooling) after 30 minutes. The set temperature will increase again by another 1°C
after an additional 30 minutes. This new temperature will be maintained for 7 hours
before it returns to the original selected temperature. This ends the Sleep mode and
the unit will continue to operate as originally programmed.
NOTE: SLEEP model cannot be used under FAN or DRY mode.
19