Husqvarna 335XPT Workshop Manual page 36

!
WARNING!
The fuel used in the chain saw poses the
following hazards:
• The fluid and its vapours are poisonous.
• Can cause skin irritation.
• Is highly inflammable.
Assembly
Assemble the following parts:
1. Fit the engine unit from the clutch side and at the same
time slide on the oil pipe (E).
2. Grip the manifold rubber, using flat pliers, through the hole
in the tank unit and carefully pull it up.
3. Fit the chain catcher, bolts (C) and guard (D).
4. Fit bolt (A) and the pulse hose (B).
Assemble the following parts:
5. Fit the ignition system and spark plug. See page 22.
6. Fit the starter. See page 20.
7. Fit the carburettor. See page 31.
8. Fit the muffler. See page 16.
9. Fit the centrifugal clutch. See page 24.
10. Fit the chain and bar. See the Operator's manual.
After assembly has been completed, refuel and test run the
chain saw. See the Operator's manual.
36
– English
TANK UNIT
D
C
B
E
C
C
A