Husqvarna 335XPT Workshop Manual page 22

Cleaning and inspection
Clean all the parts, especially the flywheel and the shaft taper.
Check that the flywheel is not cracked or damaged in any other
way.
Assembly
1. Fit the starter pawls (G).
2. Fit the flywheel on crankshaft. Rotate lightly so that the
flywheel's key aligns with keyway on the crankshaft.
3. Fit counterbalance washer (I) in the groove located on
flywheel. Use a 13 mm spanner and tighten the nut (H) to
20-26 N.
4. Remove the piston stop, fit the spark plug and rotate the
flywheel so that its magnet is beside one of the ignition
module's bolt holes.
5. Fit ignition module (F). Connect the cable (D) to the ignition
module.
6. Insert a feeler gauge (0.3 mm/ 0.012") between flywheel
magnet and the ignition module. See service tools. Tighten
the ignition module's bolts to 2.5-4 Nm.
NOTE! When fitting the ignition module the gap shall
be set between both upper arms.
7. Fit the cooling air guide (B) and starter (A).
Fitting the spark plug cover
1. Push the HT cable through the spark plug cover.
2. Make a hole in the HT cable for the contact spring using the
pliers 502 50 06-01.
3. Fit the contact spring using the pliers.
NOTE!
It is important that the tip of the contact spring comes in
the centre of the HT cable to prevent sparking.
22
– English
IGNITION SYSTEM
G
H
I
A
D
F
G
0.3 mm/ 0.012"
B