Husqvarna 335XPT Workshop Manual page 34

Replacing the fuel pipe and fuel filter
1. Remove the fuel filter and attached pipe using hook
502 50 83-01.
2. Pull the pipe out through the rubber grommet.
3. Remove the rubber grommet.
4. Fit a new rubber grommet on the pipe so that the pipe
protrudes approx. 80 mm/ 3.15".
5. Insert the pipe from the outside and push the rubber
grommet in so it is secured in the hole.
6. Pull out the pipe from the tank using hook 502 50 83-01, cut
off the end and fit the filter.
7. Push the other pipe end up through the hole in the tank
unit. Adjust so that the pipe sticks out approx. 35 mm/ 1.40".
The pipe may need to be shifted in the rubber grommet.
Replacing the tank ventilator, fuel tank
1. Push a screwdriver into the ventilator, turn and dismantle
the ventilator.
2. Push in a new ventilator by using the handle of the screw-
driver.
Replacing the oil pipe and screen
1. Remove the screen and attached pipe using hook
502 50 83-01.
2. Pull out the pipe through the oil tank.
3. If necessary dismantle the screen and clean.
4. Fit a new pipe from the outside through the hole in the oil
tank. Let the pipe protrude 40 mm/1.60" above the flat
surface. The total length of the pipe should be
165 mm/6.50".
6. Pull the pipe out through the tank using hook 502 50 83-01,
cut off the end and fit the screen.
34
– English
TANK UNIT
L = 35 mm/ 1.40"
80 mm/ 3.15"
L = 40 mm/ 1.60"