Husqvarna 335XPT Workshop Manual page 15

Assembly
Assemble the chain brake as follows:
1. Screw together the brake band and knee link.
2. Grease the moving parts on the knee link and assemble the
unit in the cover and knock in pin (E).
3. Fit the kickback guard, insert the two pins and fit the circlips
(B) and (C).
4. Put the brake in the on position and fit the spring. Press it
down by using a screwdriver on the back edge.
5. Fit the cover and tighten the four bolts (D).
6. Move the brake to the off position and fit the clutch cover on
the chain saw. Adjust the chain tension, see the Operator's
manual. Tighten the nut to 15 Nm.
SAFETY EQUIPMENT
E
B
C
D
D
D
D
15
English –