Husqvarna 335XPT Workshop Manual page 17

Throttle lock and stop function
Dismantling
Dismantle the throttle lock as follows:
1. Dismantle the clutch cover and carburettor cover.
2. Knock out the pins (B) and (C) from the left-hand side and
unscrew the bolt (D) and pull up the throttle lock (A).
3. Disconnect the choke rod (G) from the carburettor using a
screwdriver and dismantle the choke lever/stop button.
4. Use a pair of thin-nosed pliers and dismantle the lock plate
(E).
5. Disconnect the throttle's bearing (F).
6. Lift out the throttle (H). When the throttle is halfway out
push away the throttle rod (I) from the fastening in the
throttle.
6. Disconnect the electrical connection on the lock plate (E)
and choke lever/stop button (J).
Inspection
Clean all parts and check the following:
1. That the throttle lock's activation mechanism (K) is not
worn.
2. That the heel (L) on the choke lever/stop button is not
worn.
3. Check that the groove (M) and spring (N) on the lock plate
are OK.
SAFETY EQUIPMENT
B
C
D
E
F
G
I
J
N
L
H
M K
K
English –
A
E
17