Battery Charging - VTech LS6425 User Manual

Getting started

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below). If necessary, place the handset in the telephone base or charger
to charge the battery. For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after 10 hours of
continuous charging. See the table on page 58 for battery operating times.
If the screen is blank or displays Place in charger, you need to charge the
handset without interruption for at least 30 minutes to give the handset enough
charge to use the telephone for a short time. When the battery is low, the
handset displays Low battery along with a flashing icon. If you are on a call in
low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
displays Place in charger
and flashes.
The screen displays
Low battery and
The screen displays
HANDSET X.
If you place the handset in the telephone base or charger without installing a
battery, the screen displays No battery.
After you install your telephone or power returns following a power outage, the
handset will prompt you to set the date and time (see page 13). To skip setting
the date and time, press
Battery status
Battery has no or
very little charge. The
handset cannot be used.
Battery has enough
flashes. charge to be used for a
short time.
Battery is charged.
/CANCEL.
OFF
Action
Charge without interruption
(about 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone base
or charger when not in use.
4
SET DATE
MM/DD/YY