Toro 78534 Operator's Manual page 13

1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lower the mower deck to the lowest height-of-cut
position.
4. Remove the bags for viewing the tube under the hood.
5. Install the upper tube into the bagger opening and
pull it back out so the rubber seal is protruding out
(Figure 20).
Figure 20
1. Upper tube
2. Bagger opening
6. With the hood in the down position, measure the
distance the tube is inside the hood.
Note: Measure from the hood plate to the edge of
the tube as shown in
to be 19 mm (3/4 inch).
3. Bagger hood
Figure 21. This distance needs
1. Hood plate
2. Upper tube
3. Hood in the down position
7. Once the 19 mm (3/4 inch) measurement has been
achieved, mark the upper tube on the out side where
the rubber seal protrudes out
Note: This is to ensure the correct position for the
upper tube when drilling the holes and connecting the
upper and lower tubes. The rubber seal must protrude
out from the bagger hood.
1. Upper tube
2. Rubber seal protruding out 4. Mark here against the
8. Install the lower tube into the upper tube
13
Figure 21
4. 19 mm (3/4 inch)
5. Edge of tube
(Figure 22).
Figure 22
3. Bagger hood
rubber seal
(Figure 23).