Table of Contents
Advertisement
6
Installing the Blower Assembly
Parts needed for this procedure:
1
Blower assembly (from the Blower and Drive Kit)
1
Spring (from the Blower and Drive Kit)
Procedure
WARNING
An uncovered discharge opening could allow the
machine to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
• Never operate the machine unless you install a
cover plate, a mulch plate, or a grass chute and
catcher.
• Make sure the grass deflector is installed when
the grass chute and catcher are removed.
1. Remove the side discharge chute from the mower deck
(Figure
13).
Figure 13
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Slide the blower assembly peg into the pivot hole. For
60-inch machines refer to
machines refer to
Figure
5. Spring installed
6. Grass Deflector
7. L-end of spring, place
behind deck edge before
installing bolt
8. J-hook end of spring
Figure 14
and for 72-inch
15.
60-inch Mower Deck
1. Blower assembly
2. Mower deck
10
Figure 14
3. Pivot hole
4. Blower assembly peg
Advertisement
Table of Contents
