Setup - Toro 78534 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
Note: Determine the left and right sides of the machine from the normal operating position.
Description
No parts required
Bagger mounting bracket
Bagger side plate
Spacer
Bolt (3/8 x 1-1/2 inches)
Bolt (3/8 x 1 inch) (for Z593 machines
only)
Flange Nut (3/8 inch)
Curved washer
No parts required
Hood assembly
Bags
Clevis pin
Hairpin cotter
Bagger belt (from the Blower and Drive
Kit)
Blower assembly (from the Blower and
Drive Kit)
Spring (from the Blower and Drive Kit)
Upper tube
Upper tube
Lower tube
Bolt (#10 x 3/4 inches)
Locknut (#10)
Washer (7/32 inch)
Belt cover (from the Blower and Drive
Kit)
Caster weight
U-bolt
Nut (1/2 inch)
Lock washer (1/2 inch)
Plate
Top weight (for 60 inch mower decks
only)
Bolt, 1/2 x 2–1/2 inch- for top weights
No parts required
No parts required
Qty.
–
Prepare the machine.
1
2
2
14
Install the bagger mounting bracket.
2
14
14
–
Tighten all mounting bolts.
1
3
Install the hood assembly and bags.
2
2
Route the bagger belt into the blower
1
assembly.
1
Install the blower assembly.
1
Size the upper tube for 60-inch
1
machines with gas engines.
1
1
3 Install the discharge tubes.
3
3
1 Install the belt cover.
2
2
4
4
Install the weights.
2
2
2
–
Adjust the parking brake.
–
Check the tire pressure.
5
Use