Table of Contents
Advertisement
Figure 8
1. Tongue
2. Ball socket
3. Coupler lever, locked
position
3. Close the coupler lever making sure it is securely locked.
4. Install the pin to lock the coupler lever (Figure 8).
5. Cross the safety chains and attach them to the holes on
the hitch (Figure 8).
6. Plug the blower wire harness connector to the tow
vehicle connector. Check to make sure the brake lights
illuminate properly with the brake pedal applied and
the taillights flash when the turning signals are use.
4. Safety chains
5. Locking pin
6. Hitch tube holster
Product Overview
Controls
Engine Stop
Press the Engine Stop button to stop the engine (Figure 9).
1. Rotate nozzle left
2. Rotate nozzle right
3. Decrease blower
output(Pressing 3 and
4 together returns engine
to idle)
Engine Start
After completing the starting sequence, press the Engine
Start button to start the engine (Figure 9). Refer to Starting
the Engine for the starting sequence.
Nozzle Direction
Press the right or left button to rotate the nozzle to the
desired direction (Figure 9).
Engine Speed
Press the Fast (rabbit) or Slow (turtle) button to increase or
decrease the speed of the engine (Figure 9).
Ignition Switch
The ignition switch (Figure 10) which is used to start and
stop the engine, has three positions: OFF, RUN and START.
Rotate key clockwise to the START position to engage the
starter motor. Release the key when the engine starts. The key
will move automatically to the ON position. To shut engine
off, rotate key counterclockwise to the OFF position.
11
1
2
3
4
5
6
g017705
Figure 9
4. Increase blower output
5. Engine start
6. Engine stop
Advertisement
Table of Contents
