Definitions - Stihl HL 75 Assembling, Safety Precautions, Operating Instructions, Maintenance

English / USA

Definitions

1. Loop Handle*
To hold the hedge cutter with both
hands.
2. Barrier Bar*
Helps keep unit at a safe distance
from operator's feet and legs.
3. Carrying Ring
The device to connect the hedge
cutter to the harness.
4. Slide Control
Starting throttle lock and stop
switch. Keeps the throttle partially
open during starting and switches
the engine's ignition off and stops
the engine.
5. Throttle Trigger Interlock
Must be depressed before the
throttle trigger can be activated.
6. Throttle Trigger
Controls the speed of the engine.
7. Spark Plug Boot
Connects the spark plug to the
ignition wire.
8. Air Filter Cover
Covers the air filter element.
9. Machine Support
For resting machine on the ground.
10. Cutting Blades
Steel blades for cutting hedges and
shrubs.
32
11. Cutting Blade Guard
Covers cutting blade when hedge
cutter is not in use.
12. Blade Drive Gear
Converts rotary motion of angle
drive into reciprocating movement
of cutting blades.
13. Angle Drive
Transmits rotary motion of drive
shaft to the blade drive gear.
14. Drive Tube
Device to connect the engine with
the gearbox.
15. Sliding Sleeve*
Sleeve for locking and unlocking the
adjusting mechanism.
16. Adjusting Lever*
Lever for swiveling cutter bar to
required angle.
17. Quadrant*
Locks the cutter bar in the required
position.
18. Fuel Tank
For fuel and oil mixture.
19. Fuel Filler Cap
For closing the fuel tank.
20. Starter Grip
The grip of the pull starter, which is
the device to start the engine.
21. Fuel Pump
Provides additional fuel feed for a
cold start.
22. Choke Lever
Eases engine starting by enriching
mixture.
23. Carburetor Adjusting Screw
For tuning carburetor.
24. Muffler
(with spark arresting screen*)
Attenuates exhaust noises and
diverts exhaust gases away from
operator.
* see "Guide to Using this Manual"
HL 75, HL 75 K