Stihl HL 75 Assembling, Safety Precautions, Operating Instructions, Maintenance page 28

8
: Pull the rope through the rotor and
secure it with a simple overhand
knot.
:
Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
:
Slide rotor onto starter post –
turn it back and forth until the rewind
spring anchor loop (8) engages.
:
Insert screw and tighten down
securely.
: Go to "Tensioning the rewind
spring".
HL 75, HL 75 K
Replacing a broken rewind spring
: Lubricate the new spring with a few
drops of non-resinous oil – see
"Special Accessories"–, do not open
the wire retainer
:
Remove the rope rotor.
:
Remove parts of old spring.
:
Fit the new spring –
position outer spring loop in the
recess – the wire retainer slips off in
this process.
English / USA
a = 2mm
(0.08in)
If the spring has popped out:
Refit it in the counterclockwise
direction –
starting outside and working inward.
:
Install the rope rotor.
:
Check dimension "a" on inner
spring loop and bend it to size if
necessary.
:
Go to "Tensioning the rewind
spring".
27