General Control - Sharp HT-SB603 Operation Manual

Remote control (continued)
„ Checking the remaining amount
of battery level
The battery level is shown by the battery indicator during
operation.
When the battery
When the battery
level is high
level is high
z When the battery level is very low, "Battery Low!" will
appear on the display, then the remote control will be
turned off automatically.
z Replace the batteries with new ones.
Notes:
z The battery indicator will not correctly display the
remaining capacity for approximately 10 seconds after
the power has been turned on.
z The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.
z The battery life and the operating time may be
shortened by usage conditions, long periods of disuse,
etc.
„ USB connection
To operate the remote control without battery power,
connect a Micro USB cable (not supplied) to the remote
control DC IN terminal.
z Connection of the USB cable to the remote control
disconnect the batteries.
Caution:
The USB connection cannot be used to charge the
remote control or as a media playback.
„ Test of the remote control (Sharp TV operation)
Point the remote control directly at the remote sensor on
the TV.
The remote control can be used within the range
shown below:
0.2 m - 6 m
Battery indicator
Battery indicator
When the battery
When the battery
level is very low
level is very low
To power
source
Remote
sensor
15° 15°

General control

Make sure to enable the HDMI CEC when making
HDMI connection. For details, refer to the operation
manual of the TV.
„ To turn the power on
Press the ON/STANDBY button on the sound bar or the
button on the remote control.
z The power turns on and the sound bar on/standby/
pairing/input indicator lights up according to the input
source. If the power does not turn on, check whether
the AC power lead is plugged in properly.
Input source
Bluetooth
Others
z The system will automatically power on if TV or similar
component which supports HDMI CEC, is turned on.
To set the sound bar to standby mode:
Press the ON/STANDBY button on the sound bar or the
button on the remote control. The sound bar
on/standby/pairing/input indicator turns red.
Notes:
z A slight audio delay after TV is turned ON does not
mean that the system is faulty. This is normal.
z "AQUOS speaker is enabled" message will be
displayed if SHARP LCD TV does not detect HT-SB603
during power on. However the message "AQUOS
audio with AQUOS LINK is enabled" will be displayed
soon as HT-SB603 is detected. These messages may
vary for other TV model.
„ Eco mode
z The first time the unit is plugged in, it will enter standby
mode (ECO mode off). Sound bar indicator turns red.
z To cancel the standby mode, perform the following
method.
Remote Control:
1. Select ECO MODE ON from remote control menu
(Refer 'To select a menu on the remote control on
page 12). The next time the unit is turned off it will
enter the low power consumption mode (Sound bar
indicator turns off).
2. To return to the standby mode, select ECO MODE
OFF. The next time the unit is turned off it will enter
standby mode.
E-11
Indicator
Blue.
Violet.