Assembly Guide - Vision Fitness Multi-Station Gym ST710 Owner's Manual

A s s e m b l y &
O w n e r ' s G u i d e
ST710
MULTI-STATION GYM
To avoid possible damage to this Multi-Station Gym, please follow these assembly steps in the correct order. Before
proceeding, find your new Multi-Station Gym serial number located on the side of the leg press floor support (AC3),
and enter here:
Refer to this number when calling for service, and enter this serial number on your Warranty Card and in your
own records. Be sure to read your Assembly/Owner's Guide before using your new Multi-Station Gym.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12.
NOTE: During assembly, it is recommended to ensure that all bolts are in place and partially threaded
before completely tightening any one bolt. During assembly steps 1 thru 6, do not completely tighten
any bolts until completion of Step 6. Also, it is recommended to apply grease to the fittings of the
pillow block bearings on the Leg Press station. This will ensure smooth operation and prevent rust.
4