Step 2: Blue Bag - Vision Fitness Multi-Station Gym ST710 Owner's Manual

BLUE BAG
2
STEP
• Place the center connecting support
(AC6) in between the functional arm floor
support and the leg press arm floor
support, aligning the holes. Slide two bolts
(M10x62) with flat washers (10.2x22x2)
through the holes into the functional arm
floor support. Secure bolts with two more
flat washers and two nylon nuts (M10).
Repeat on other side of connecting support.
• Attach two pillow block bearings (C33)
to the leg press foot (AC4) with four
bolts (M10x25), four lock washers
(10.2x18.4x2.5), and four flat washers
(10.2x22x2). Make sure the grease fittings
are positioned on the inside, pointing
towards the main center upright. Tighten.
• Take the leg press foot (AC4) and place
over the end of the leg press floor support
(AC3), aligning the holes. Slide two bolts
(M10x62) with flat washers (10.2x22x2)
through the holes, securing with two more
flat washers and two nylon nuts (M10).
• Loosely thread four set screws (M6x8) in
the axle housing on the leg press swing
7
arm (AN1). Place the axle (8 / ") housing
AN2
16
of the leg press swing arm between the
AN1
pillow block bearings on the leg press
foot, making sure the pulley bracket is facing
the floor support. Slide the axle through
the holes and center it in the bearings.
Secure by tightening set screws.
C33
• Attach the foot plate (AN2) to the leg
press swing arm (AN1) by sliding the shaft
(5.75") through holes in foot plate and
AC4
swing arm, and securing with a flat washer
(12.2x26x2), lock washer (10.2x18.4x2.5)
and a bolt (M10x25).
• Attach the leg curl post (AH2) in
between the bracket on the press arm floor
support (AC1) using one bolt (M10x72),
AC1
two flat washers (10.2x22x2), and a
AC3
nylon nut (M10).
AC6
AH2
12