Vision Fitness ST720 Owner's Manual page 15

BLACK BAG
5
STEP
• Secure top and bottom shield brackets
QO5) to weight stack tower (AB1) using
bolts (M5x10), flat washers (5.2x10x1.5),
and lock washers (5.1x9.3x1.3) provided.
Repeat for all side brackets (QO4).
• Place two rubber weight plate bumpers
(K10) over the holes in the lower cross tube
of the weight stack tower. With the horizontal
holes of the guide rods at the bottom, place
them over and through the rubber weight
plate bumpers into the weight stack tower.
Let the guide rods tilt outward from the
tower. Slide each of the 20 weight plates
(K02) over both of the guide rods on top of
one another. Place the header weight plate
(K01) over both guide rods on top of other
weight plates.
• Slip the rubber guide rod sleeves (K11)
over the top of the guide rods, then snap
into holes in the weight stack tower. Lift the
guide rods into top of weight stack tower
until holes in the guide rod are lined up with
the horizontal holes at the top of the weight
stack tower. Insert a bolt (M8x62) and flat
washer (8.4x15.5x1.6) through each guide
rod and fasten with a flat washer
(8.4x15.5x1.6) and a nut (M8).
15