Power-Adapter Port; Removing The Power-Adapter Port - Dell Alienware m17 R3 Service Manual

Steps
1. Place the fan and heat-sink assembly on the system board.
2. In sequential order (1>2>3>4>5>6>7>8>9>10), replace the ten screws (M2x3) that secure the fan and heat-sink assembly to
the system board.
NOTE: The number of screws varies depending on the configuration ordered.
3. Connect the left and right fan cables to the system board.
Next steps
1. Follow step 3 to step 22 in installing the
2. Install the battery.
3. Install the rear I/O-cover.
4. Install the 2280 solid-state drive in M.2 slot
5. Install the 2230 solid-state drive in M.2 slot
6. Install the 2280 solid-state drive in M.2 slot
7. Install the 2230 solid-state drive in M.2 slot
8. Install the base cover.
9. Follow the procedure in

Power-adapter port

Removing the power-adapter port

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 2230 solid-state drive in M.2 slot
4. Remove the 2280 solid-state drive in M.2 slot
5. Remove the 2230 solid-state drive in M.2 slot
6. Remove the 2280 solid-state drive in M.2 slot
7. Remove the rear I/O-cover.
54
system board.
two, if installed.
two, if installed.
one, if installed.
one, if installed.
After working inside your
Before working inside your
one, if installed.
one, if installed.
two, if installed.
two, if installed.
computer.
computer.