Palmrest; Removing The Palm Rest - Dell Alienware m17 R3 Service Manual

Steps
1. Place the keyboard on the palm-rest assembly.
2. Replace the 28 (M1.2x1.6) screws that secure the keyboard to the palm-rest assembly.
NOTE: The 28 screw holes are marked with an arrow.
3. Place the keyboard bracket on the keyboard.
4. Replace the ten (M1.2x2.1) screws that secure the keyboard bracket to the keyboard.
5. Connect the keyboard cable to the keyboard-controller board and close the latch.
6. Connect the keyboard-backlight cable to the keyboard, and close the latch.
Next steps
1. Follow step 3 to step 22 in installing the
2. Install the right I/O-board.
3. Install the battery.
4. Install the rear I/O-cover.
5. Install the 2280 solid-state drive in M.2 slot
6. Install the 2230 solid-state drive in M.2 slot
7. Install the 2280 solid-state drive in M.2 slot
8. Install the 2230 solid-state drive in M.2 slot
9. Install the base cover.
10. Follow the procedure in

Palmrest

Removing the palm rest

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 2230 solid-state drive in M.2 slot
4. Remove the 2280 solid-state drive in M.2 slot
5. Remove the 2230 solid-state drive in M.2 slot
62
system board.
two, if installed.
two, if installed.
one, if installed.
one, if installed.
After working inside your
Before working inside your
one, if installed.
one, if installed.
two, if installed.
computer.
computer.