Flea Power Release; Wifi Power Cycle - Dell Alienware m17 R3 Service Manual

Table 11. LED codes (continued)
Diagnostic light codes
3,6
3,7
Camera status light: Indicates whether the camera is in use.
• Solid—Camera is in use.
• Off—Camera is not in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.
• Solid—Caps Lock enabled.
• Off—Caps Lock disabled.

Flea power release

About this task
Flea power is the residual static electricity that remains on the computer even after it has been powered off and the battery has been
removed. The following procedure provides the instructions on how to conduct flea power release:
Steps
1. Turn off your computer.
2. Disconnect the power adapter from your computer.
3. Remove the base cover.
4. Disconnect the battery cable from the system board.
5. Press and hold the power button for 15 seconds to drain the flea power.
6. Connect the battery cable to the system board.
7. Install the base cover.
8. Connect the power adapter to your computer.
9. Turn on your computer.

WiFi power cycle

About this task
If your computer is unable to access the internet due to WiFi connectivity issues a WiFi power cycle procedure may be performed.
The following procedure provides the instructions on how to conduct a WiFi power cycle:
NOTE: Some ISPs (Internet Service Providers) provide a modem/router combo device.
Steps
1. Turn off your computer.
2. Turn off the modem.
3. Turn off the wireless router.
4. Wait for 30 seconds.
5. Turn on the wireless router.
6. Turn on the modem.
7. Turn on your computer.
78
Problem description
System BIOS Flash incomplete
Management Engine (ME) error