Fan And Heat-Sink Assembly; Removing The Fan And Heat-Sink Assembly - Dell Alienware m17 R3 Service Manual

Steps
1. Using the alignment pins, place the interposer board on the system board.
2. Using the alignment pins, connect the left I/O-board to the system board through the interposer board.
3. Align the screw holes on the left I/O-board with the screw holes on the system board and interposer board.
4. Replace the four screws (M2x4.5) that secure the left I/O-board to the system board.
Next steps
1. Follow step 3 to step 22 in installing the
2. Install the battery.
3. Install the rear I/O-cover.
4. Install the 2280 solid-state drive in M.2 slot
5. Install the 2230 solid-state drive in M.2 slot
6. Install the 2280 solid-state drive in M.2 slot
7. Install the 2230 solid-state drive in M.2 slot
8. Install the base cover.
9. Follow the procedure in

Fan and heat-sink assembly

Removing the fan and heat-sink assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the 2230 solid-state drive in M.2 slot
4. Remove the 2280 solid-state drive in M.2 slot
5. Remove the 2230 solid-state drive in M.2 slot
6. Remove the 2280 solid-state drive in M.2 slot
7. Remove the rear I/O-cover.
8. Remove the battery.
9. Follow step 1 to step 21 in removing the
system board.
two, if installed.
two, if installed.
one, if installed.
one, if installed.
After working inside your
Before working inside your
one, if installed.
one, if installed.
two, if installed.
two, if installed.
system board.
computer.
computer.
51