Uv Sterilization Function; Sterilized Water; Automatic Energy Saving Function; Inlet Water Filtration - Kohler K-77795 Series Homeowner's Manual

UV Sterilization Function*

UV function is used to sterilize the nozzle by UV.
Automatic UV sterilization
When toilet is not in use for a long time, auto UV sterilization function will be activated and start sterilizing
¨
nozzle. The process shall be 45min. No sterilization function shall be activated after this process in another 24
hours.
During UV steriliztion process, if customer open cover and start use toilet, or presses Stop button on remote,
¨
UV sterilization function will be deactivated.
Auto UV sterilization function setting refers to Page 9.
¨
Manual UV sterilization
When unseated, press "One button sterilization" button on remote to activate UV sterilization function (details
¨
are shown in the diagram of remote control).
During sterilization process, if customer open cover and start use toilet, or presses Stop button on remote, UV
¨
sterilization function will be deactivated.
* UV sterilization (refer to the ultraviolet sterilization generated by UV lamp): During UV working cycle, the bacteria on
nozzle surface will be eliminated by iirradiation. The antibacterial rate is more than 99% (Measured after one UV working
cycle, it was measured within 18mmx8mm irradiation area. Perform test in accordance with GB/T23131 requirements, UV
radiation zone was shown in the diagram, UV working cycle activation mode refers to users guide.)

Sterilized Water*

Perform Nozzle sterilization function by using sterilized water.
After use front wash, rear wash or spiral wash etc. functions, toilet activates sterilization function after leaves
¨
toilet.
Manual sterilization function.
When unseated, press remote "Sterilization" button to activate nozzle sterilization function/bowl clean
¨
function (details refer to remote user's guide).
* Sterilized water (refers to the tap water containing hypochlorite generated by chlorine ions after ionization):
Sterilization water generated during electrolysis working cycle eliminates bacteria on the nozzle surface. The antibacterial
rate is more than 96% (Perform test in accordance with GB/T 23131 when the content of chlorine ions in tap water is > 24
ppm. Different water quality might cause different sterilization effect. Electrolysis working cycle activation method refers
to operation description.

Automatic Energy Saving Function

1. When energy saving set to ON status, product shall auto detect the idle hours and decrease the heating
temperature to reach of energy saving purpose.
2. For details of automatic energy saving, refer to page 9.

Inlet Water Filtration

Purified water used for Rear wash/Spiral wash/Front wash.
When filter almost expires, orange LED keeps ON (as shown).
¨
When filter has expired and require replacement, orange light blinks.
¨
Orange and white LED blinks alternately indicate improper filter installation.
¨
For filter exchange refer to page 18.
¨

Deodorization

Product default factory setting is auto activate deodorizer function when detecting customer seated.
¨
Refer to Remote Setting for how to switch over auto deodorization function.
¨
1295780-X5-C 16 Kohler Co.