Auxiliary Keyboard Function; Uv Sterilization Function; Sterilization - Kohler K-77780KR-0 Homeowner's Manual

Auxiliary keyboard function

D.Press button to activate front wash
Notes:
1. Each function will enter a mode according to factory setting.
2. When front/rear wash is ON, activate corresponding function, auto deactivated after 5 min.
3. When dryer is ON, activate this function, auto deactivated after 4 min.
4. Use STOP button to deactivate front/rear wash/dryer function.
Wide range clean mode
1. The Bidet is equipped with wide oscillate clean function. If you would like to use wide oscillate function,
please hold rear wash + STOP key about 2s on auxiliary panel after activate rear wash function.
Standby function
1.
Hold " " button on side panel (over 2s), enter standby mode when hear one "beep" generated.
Auto detection or remote function deactivated, the top indication LED off. Ring heating function stops
to decrease energy saving.
2. When press any button on side panel or seat on, auto deactivate standby mode, all function recovered.

UV sterilization function *

UV function sterilizes the nozzle with ultraviolet ray. UV function can be activated only under non-
●
seating status.
Automatic UV sterilization
●
If the product is not used for a long time, the function of UV sterilization will be activated automatically. By this way,the nozzle
□
will then be sterilized. The function will not be activated again for another 24 hours.
Kohler Co.
B.Press button to
activate rear wash
A.Press dryer button to activate
dryer function
C.Light sensing area
F. Under unseated status, hold rear
wash or front wash button until wand
extend, perform manual clean on
nozzle, hold STOP button to terminate
manual clean function.
12
E.1.Standby function
Hold " " button (over 2s) to enter
standby mode. Details refer to "Standby
function" chapter on page 12.
2. Stop function.
Press " " button to stop flushing, dryer, air
purification, one button sterilization, manual
wand clean or UV function.
1308458-KR01-B