Auxiliary Keyboard Function; Wide Clean Oscillate Mode; Standby Function - Kohler K-77795 Series Homeowner's Manual

Auxiliary Keyboard Function

UV radiation range
NOTE:
Each function performance shall conform to factory setting.
¨
When use the Front wash/Rear wash mode, activate corresponding function, auto deactivate after 5 minutes.
¨
Deactivate Front wash/Rear wash/Dryer function by pressing"
¨
Use " " button to flush bowl.
¨
Wide Oscillate Clean Function
The Bidet is equipped with wide oscillation clean function. If you would like to use wide oscillate function, push
and hold Rear wash and Stop button about 2 seconds before activate Rear wash and Oscillate function; activate
Oscillate function.

Standby Function

Push and Hold "
¨
Auto detection and remote function deactivated at this point. Seat heating function deactivated to minimize
energy consumption.
When press any button on side panel or seated, auto exit standby mode, all function recovered.
¨
Kohler Co.
D. Press button to stop all functions.
B. Press button to enter
rear wash
A. Press button to
enter front wash
C. Light sensor area
Bidet nozzle
Bidet nozzle
" button (over 2 seconds) on side panel, enter standby mode when generate one "beep".
D. 1. Standby function
Push and hold (more than 2 seconds)
" " button to enter standby mode, details
are shown in Page 15 "standby function" item.
2. Stop function
Press " " button to stop fIush, dryer,
air purification, One button sterilization
function, manual nozzle clean and UV function.
F. When unseated, push and hold rear or
front wash button until nozzle extension,
perform manual clean for nozzle,press "
button to deactivate manual clean function.
" button.
15
E. Press to perform
fIush full, push and
hold " " for 2 seconds
to enter emergency
fIush mode when power
is Off.
"
1295780-X5-C