Table of Contents
Advertisement
Auxiliary keyboard function
Note:
1. Each function performance shall conform to factory setting.
2. When use the front wash/rear wash mode, activate corresponding function, auto deactivate after 5min.
3.
Deactivate front wash/rear wash/dryer function by pressing "
4.
Use "
" button to flush bowl.
Wide oscillate clean function
The Bidet is equipped with wide oscillate clean function. If you would like to use wide oscillate function, push
and hold rear wash + STOP button about 2s before activate rear wash + oscillate function; activate oscillate
function.
Standby mode
1.
Push and hold "
" button (over 2s) on side panel, enter standby mode when generate one "beep". Auto
detection and remote function deactivated at this point, top indicating LED OFF. Seat heating function
deactivated to minimize energy consumption.
2. When press any button on side panel or seated, auto exit standby mode, all function recovered.
UV sterilization function*
1. UV function is used to sterilize the nozzle by UV.
2. Auto UV sterilization
When toilet is not in use for a long time, auto UV sterilization function will be activated and start sterilizing
nozzle. No sterilization function shall be activated after this process in another 24hrs.
During UV sterilization process, if customer start use toilet, or presses STOP button on remote, UV
sterilization function will be deactivated.
Auto UV sterilization function setting refers to Page 9.
Kohler Co.
B. Press button to enter
rear wash
A. Press button to
enter front wash
C. Light sensor area
Bidet nozzle
F. When unseated, push and hold rear or front wash
button until nozzle extension, perform manual clean
for nozzle, press "
clean function.
D. Press button to stop all functions.
D 1. Standby mode
Push and hold (more than 2s) "
standby mode, details are shown in Homeowner's
Guide Page 15 "standby mode" item.
2. Stop function
Press "
dryer, air purification, One button sterilization function,
manual nozzle clean and UV function.
" button to deactivate manual
"button.
15
E. Press to perform flush full, push
and hold "
" for 2s to enter
emergency flush mode when
power is off.
" button to enter
" button to stop front wash, rear wash,
1373171-KR01-A
Advertisement
Chapters
Table of Contents
