Auxiliary Key Function; Wide Oscillate Mode; Standby Mode - Kohler EIR Homeowner's Manual

Auxiliary keyboard function
UV radiation range
Note:
1. Each function performance shall conform to factory setting.
2. When use the front wash/rear wash mode, activate corresponding function, auto deactivate after 5min.
3. Deactivate front wash/rear wash/dryer function by pressing "
4. Use " " button to flush bowl.
Wide oscillate clean function
The Bidet is equipped with wide oscillate clean function. If you would like to use wide oscillate function, push
and hold rear wash + STOP button about 2s before activate rear wash + oscillate function; activate oscillate
function.

Standby mode

1. Push and hold "
detection and remote function deactivated at this point, so as IoT function (for IoT models), top indicating
LED OFF. Seat heating function deactivated to minimize energy consumption.
2. When press any button on side panel or seated, auto exit standby mode, all function recovered.
Kohler Co.
B. Press button to enter
rear wash
A. Press button to
enter front wash
C. Light sensor area
Bidet nozzle
" button (over 2s) on side panel, enter standby mode when generate one "beep". Auto
D. Press button to stop all functions.
F. When unseated, push and hold rear or front wash
button until nozzle extension, perform manual clean
for nozzle, press " " button to deactivate manual
clean function.
Bidet nozzle
"button.
15
E. Press to perform flush full, push
and hold "
emergency flush mode when
power is off.
D 1. Standby mode
Push and hold (more than 2s) "
standby mode, details are shown in Page 15 "standby
mode" item.
2. Stop function
Press " " button to stop flush, dryer, air purification,
One button sterilization function, manual nozzle clean
and UV function.
" for 2s to enter
" button to enter
1413624-T01-B