Headlamp Bezel; Headlamp (Cross Country) - Victory Cross Roads Classic Service Manual

Headlamp Bezel

Removal
1. Using body tool PV-49955, pry one edge of bezel
from fairing then pull straight forward to release clips.
Do not bend or rotate bezel during removal.
Installation
1. Align tabs with spring clip slots.
2. Push straight inward until seated.
NOTE: Headlamp removal is on page 3.9.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

Headlamp (Cross Country)

Also refer to Assembly View on following page.
Removal
1. Remove headlamp bezel (page 3.9).
2. Remove two upper screws (A) and 2 lower screws (B).
3. Slide headlamp out of fairing.
4. Note orientation of bulbs in headlamp. Top bulb wiring
harness faces left.
5. Lift tab to disconnect headlamp wire harness or turn
each bulb socket 1/4 turn to remove socket with wires
attached. Do not touch glass surface of bulb. Bulb can
be cleaned with isopropyl alcohol to remove oil
residue if contaminated.
© Copyright 2012 Polaris Sales Inc.
FRAME-BODY-EXHAUST
85 in-lbs (9.6 Nm) (All Screws)
A
B
B
3
A
Euro only
3.9