Windshield (Cross Country Tour) - Victory Cross Roads Classic Service Manual

Windshield (Cross Country Tour)

Removal
1. Loosen all shoulder screws (6) and nuts (Fig. 3) about 1/2 turn.
2. Support windshield and completely remove all screws and windshield.
Installation
1. Fairing removal is not required for windshield installation. Place windshield on supports and align screw holes.
2. Verify that rubber washers are in place (Fig. 4). If any rubber washers (6) are missing, they must be replaced. Start
all screws and tighten until the shoulder of each screw is close to the windshield.
3. Tighten the screws, starting with top two. Carefully align the shouldered portion of the screw with the hole in the
windshield. Be sure the shoulder of the screw passes through the hole in windshield and bottoms out on the bracket.
4. Torque all screws evenly to 36 in-lbs (4.1 Nm). Do not overtighten screws or windshield may be damaged.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Tighten top screws first
© Copyright 2012 Polaris Sales Inc.
FRAME-BODY-EXHAUST
3
3.7