Lincoln Electric VRTEX 360 Operator's Manual page 35

Menu
Selecting Logout and then yes in the submenu takes
the user back to the Login screen.
Selecting Change Process brings the user back to the
tolerances process selection screen.
Back
Pressing Back goes back to the previous screen.
Continue
Pressing Continue goes to the tolerance process
selection screen.
Tolerances Process Selection Screen
Overview
The user selects which process to modify.
TOLERANCES PROCESS SELECTION SCREEN
Menu
Selecting Logout and then yes in the submenu brings
the user back to the login screen in welding mode.
Selecting Change Coupon Type takes the user back to
the tolerances configuration selection screen.
Back
Pressing Back goes back to the tolerance configuration
selection screen.
Continue
Pressing Continue goes to the tolerance equipment
settings screen
English
Modifying Tolerances
Overview
The user can modify the tolerance values. This is done
by:
1) Use the joystick to highlight the equipment setting or
parameter to change.
2) Press the red select button.
3) Use the joystick to change the value. Pressing the
green set tolerances button will save the changes.
The following screens are used to modify tolerances:

Tolerances Equipment Settings screen

Tolerances Gas screen

Tolerances Welding Technique Parameters screen

Tolerances Pattern and Aim screen

Tolerances Whip and Travel Speed screen

Tolerances Weave screen
Next & Previous
Use the arrow buttons to cycle through the tolerance
editor screens.
The configuration and process selected are shown at the
top of the screen.
In the upper right of the screen is the name of the
tolerance set being modified.
Ideal values represent the ideal weld technique
parameters. If the user welds using the technique listed
as ideal, they will get the best score. The ideal values
are represented by the red line on the LASER screen.
Changing the +/- changes the acceptable tolerance
indicated by the white lines on the LASER screen.
Any welding technique used within that +/- range is
acceptable but will be scored lower the further it is from
the ideal value. As an example, a work angle with an
ideal of 45 degrees and a +/- of 10 degrees means that
the user can use a work angle between 35 and 55
degrees and create an acceptable weld.
Settings that are non-applicable to the process selected
are greyed out and cannot be changed.
Menu
This is the same as the tolerance configuration selection
screen.
Back
Pressing back goes to the previous screen without
Saving changes.
Prev Pass
The previous pass button changes the pass being
modified. If this is the first pass, this option is not
available. The pass number currently being modified is
shown in the upper right of the screen.
Next Pass
The next pass button changes the pass being modified
to the next pass in the series. If this is the last pass, this
option will not be available.
32
English