Lincoln Electric VRTEX 360 Operator's Manual page 12

2. Remove the cable ties from monitor cables secured
to the monitor mounting post.
3. Use a Phillips-head screwdriver to carefully mount
the monitor onto the mounting post bracket. Tighten
the four Phillips-head screws securely.
4. Connect input power cable and VGA cable into the
monitor.
APPLY SYSTEM POWER:
1. Insert the input supply power cord into the back of
®
the VRTEX 360 and into a standard electrical
outlet capable of 115 to 230 VAC at 4 to 2 Amps.
NOTE: Surge protector (or Surge Suppessor) may be
required to protect the electronic components of
the machine from input power surges.
2. Verify Circuit Breaker/Rocker Switch is in the On
position. (See Figure "Back of Machine")
ADDITIONAL FUTURES:
1. The welding coupons are stored in the coupon
drawer in the rear of the machine.
BACK OF MACHINE
VGA Out
English
Input Power
connection
Always in the
ON position
Audio Jack
9
2. The weld simulation can be displayed on an external
monitor or projector by using the VGA output on the
back of the machine. The external display must
support 1024x780 resolution.
3. External speakers may be connected using the
audio jack located on the back of the machine.
TRACKING SYSTEM FUNDAMENTALS:
The magnetic tracking system is composed of the
following:

Control Unit (Inside VR Machine)
Contains the hardware and software
-
necessary to compute position and
orientation.

Source (part of the Swing Arm)
The source contains electromagnetic coils
-
enclosed in a plastic shell that emit a
magnetic field. The source is the system's
reference frame for sensor measurements.

Sensor (in the VR GMAW/FCAW gun, VR SMAW
device, and helmet)
- The sensor contains electromagnetic coils
enclosed in a plastic shell that detect the
magnetic fields emitted by the source. The
sensor's position and orientation are precisely
measured as it moves in reference to the
source. The sensor is completely passive,
having no active voltage applied to it.
English