Lincoln Electric VRTEX 360 Operator's Manual page 17

VR COUPONS
The coupons along with the VR SMAW device and VR
GMAW/FCAW gun have been factory calibrated at
Lincoln Electric.
Stand
The stand is comprised of the post, arm, table, Three
pins, base and two weights. Users should position
themselves at the stand during virtual welding.
Post
The arm and table slide up and down and rest on the
collar pins that are inserted into the post. Hole numbers
0 through 28 indicate position of welding for program
accuracy. The position that the table or arm is located is
read by identifying the numbered hole that the pin has
been inserted into.
POST W/PIN INSERTED IN #18
PIN POSITION
Coupon Positioning In Swing Arm
The coupons can be inserted into the arm to
accommodate flat, horizontal, vertical or overhead
welding positions. The knob on the front of the swing
arm can be pulled out for coupons to be inserted or
removed and pushed in for coupons to be secured. The
front of the swing arm can be rotated down at a 45 or 90
degree angle to allow 2G, 5G and 6G pipe welding
positions. The arm can also be rotated around the post
to comfortably accommodate left and right handed
welders or simulate specific welding applications.
English
COUPON INSERTION / REMOVAL
Do not use excessive force when inserting and removing
coupons into the arm..
SWING ARM ROTATION
POSITION A
Table
The table can be used to gain stability and learn proper
body positioning. The base supports the stand and has
weights on the back to maintain stability. The table can
be swung out of the way when not in use.
Do not use the Stand/Table without the base counter
weights properly positioned.
TABLE ROTATION
14
WARNING
POSITION C
POSITION B
WARNING
English