Lincoln Electric VRTEX 360 Operator's Manual page 26

CTWD (Contact Tip to Work Distance)
The Arc Length cue is similar to the CTWD cue but
represents arc length distance for the VR SMAW
process. The goal is to get the tip of the arrow on the line
and keep the arrow color Green.
The Travel/Work Angle cue can be used with the
SMAW, GMAW or FCAW processes. The goal of this
cue is to center the circle in the cross hair and keep the
color green.
TRAVEL/WORK ANGLE
The Aim cue can be used with the VR SMAW, VR
GMAW or VR FCAW processes. The goal of this cue is
to position the VR GMAW/FCAW Gun or VR SMAW
device so the aim cue is a thin green line. This indicated
that the weld is being made in the correct location or
position.
English
The Whip cue can be used with the E6010 VR SMAW
process. This cue helps the student use correct spacing
between whipping motions, puddle time and whip time.
Correct whipping technique is indicated by a green
outter ring (spacing) with a green center (puddle and
whip timing).
The Weave cue can be used with the VR SMAW, VR
GMAW or VR FCAW processes but is only available if
the technique identified in the Tolerance Editor is a type
of weave. The goal of this cue is to space the weave so
the outter ring is green (good weave spacing), set the
width of the weave so line is green (good weave width)
and a green filled ring (good dwell time on the toes of the
previous weld).
23
AIM
WHIP
English