ZyXEL Communications LTE Series User Manual page 29

2.2.1.2 Navigation Panel
Use the menu items on the navigation panel to open screens to configure Zyxel Device features. The
following tables describe each menu item.
Table 8 Navigation Panel Summary
LINK
Home
Network Setting
Broadband
Wireless
Home
Networking
Routing
Chapter 2 The Web Configurator
TAB FUNCTION
Use this screen to configure basic Internet access and wireless settings.
This screen also shows the network status of the Zyxel Device and
computers/devices connected to it.
Broadband Use this screen to view and configure ISP parameters, WAN IP address
assignment, and other advanced properties.
Ethernet WAN Use this screen to convert the fourth LAN port as WAN port, or restore the
WAN port to LAN port.
Cellular WAN Use this screen to configure an LTE WAN connection that includes the
Access Point Name (APN) provided by your service provider.
Cellular SIM Use this screen to enter a PIN for your SIM card to prevent others from
using it.
Cellular Band Use this screen to configure the LTE frequency bands that can be used
for Internet access as provided by your service provider.
Cellular PLMN Use this screen to view available PLMNs and select your preferred
network.
Cellular IP Use this screen to enable IP Passthrough mode (bridge mode).
Passthrough
Note: This screen is not available when the fourth LAN port acts
as an Ethernet WAN port. See
feature differences of the Zyxel Devices.
General Use this screen to configure the wireless LAN settings and WLAN
authentication/security settings.
MAC Use this screen to block or allow wireless traffic from wireless devices of
Authentication certain SSIDs and MAC addresses to the Zyxel Device.
WPS Use this screen to configure and view your WPS (WiFi Protected Setup)
settings.
WMM Use this screen to enable or disable WiFi MultiMedia (WMM).
Others Use this screen to configure advanced wireless settings.
WLAN Scheduler Use this screen to create rules to schedule the times to permit Internet
traffic from each wireless network interfaces.
LAN Setup Use this screen to configure LAN TCP/IP settings, and other advanced
properties.
Static DHCP Use this screen to assign specific IP addresses to individual MAC
addresses.
UPnP Use this screen to turn UPnP and UPnP NAT-T on or off.
Static Route Use this screen to view and set up static routes on the Zyxel Device.
DNS Route Use this screen to forward DNS queries for certain domain names through
a specific WAN interface to its DNS server(s).
Policy Route Use this screen to configure policy routing on the Zyxel Device.
RIP Use this screen to configure Routing Information Protocol to exchange
routing information with other routers.
LTE Series User's Guide
29
Table 1 on page 13 for the