Command Control Via The Network; Command Control Settings - ViewSonic PJ1158 User Manual

Command Control via the Network

Command Control va the Network
You can configure and control the projector via the network using RS-232C com-
mands.
Communication Port
The followng two ports are assgned for the command control.
TCP #23
TCP #9715
NOTE
• Command control s not avalable va communcaton port (TCP
#9716) that is used for the e-SHOT transmission function.

Command Control Settings

Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter [https://192.168.1.10] nto the address bar of the web browser.
2) Enter the Admnstrator ID and Password and clck [Logon].
3) Clck [Port settings] on the man menu.
4) C lck the [Enable] check box to open [Network Control Port (Port: 23)] to use
TCP #23. Clck the [Enable] check box for the [Authentication] settng when
authentcaton s requred, otherwse clear the check box.
5) C lck the [Enable] check box to open [Network Control Port (Port: 9715)] to
use TCP #9715. Clck the [Enable] check box for the [Authentication] settng
when authentcaton s requred, otherwse clear the check box.
6) Clck the [Apply] button to save the settngs.
ViewSonic PJ1158 88