Table of Contents
Advertisement
Setting with [Dot Clock]
Use this function to adjust the dot clock and minimize the effect of interference caused by projection of patterns
consisting of vertical stripes.
The projection of the vertical striped pattern may cause cyclic patterns (noise). Adjust so that the amount of
interference is at a minimum.
1)
Press as to select [Dot Clock].
2)
Press w or the <ENTER> button.
f The [Dot Clock] screen is displayed.
3)
Press qw to adjust the level.
f The adjustment values are [-10] to [10] and the default value is [0].
Attention
f Set it before adjusting [Phase].
Setting with [Phase]
You can adjust the clock phase to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [Phase].
2)
Press w or the <ENTER> button.
f The [Phase] screen is displayed.
3)
Press qw to adjust the level.
f The adjustment values are [0] to [31]. Adjust so that the amount of interference is at a minimum.
Note
f Certain signals may not be adjustable.
f Optimal value may not be achieved if the output from the input computer is unstable.
f To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [Phase] is adjusted.
f [Phase] cannot be adjusted when a digital signal is input.
Setting with [H. Position]
Adjust the image position if the image projected on the screen is shifted left or right even when the positions of the
projector and screen are correct.
1)
Press as to select [H. Position].
2)
Press w or the <ENTER> button.
f The [H. Position] screen is displayed.
3)
Press qw to adjust the horizontal image position.
f The adjustment values are [-5] to [5] and the default value is [0].
Orientation
Horizontal (left and
right) adjustment.
Setting with [V. Position]
Adjust the image position if the image projected on the screen is shifted up or down even when the positions of
the projector and screen are correct.
1)
Press as to select [V. Position].
60 - ENGLISH
Chapter 4 Settings - [Picture] menu
Operation
The image position moves to the right.
Press the w button.
The image position moves to the left.
Press the q button.
Adjustment
Advertisement
Table of Contents
