Table of Contents
Advertisement
Initial setting (standby mode)
Set the operating mode at standby. When the initial setting is completed, you can change the setting from the
[Setup] menu → [Eco Management] → [Standby Mode].
1)
Press qw to select the operation mode.
f The factory default setting is [Normal], which enables the network functions and the functions set in [Normal
Standby] during standby.
f To lower the power consumption level during standby, set it to [Eco.].
2)
Press the <ENTER> button to proceed to the following initial setting.
Initial setting (network function message)
The message prompting the users to set the network account is displayed.
1)
Press the <ENTER> button to proceed to the following initial setting.
Note
f To use the network functions, it is necessary to set the network account by using the web browser. For details, refer to "Web control
function" (x page 86).
Initial setting (3D safety precaution message)
The 3D safety precaution message is displayed.
1)
Press the <ENTER> button to complete the initial setting.
f If the <ENTER> button is not pressed, the message will also disappear after 30 seconds have elapsed.
42 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
Standby Mode
Network functions are limited.
Before using Network functions,
you must set Password by WEB browser.
3D Safety Precautions
To enjoy 3D images safely and comfortably,
please refer to the Operating Instructions for in-depth description.
Please refrain from viewing 3D images if you do not feel well or are
experiencing visual fatigue.
In the event that you experience dizzyness, nausea, or other discomfort
while viewing 3D images, discontinue use and rest your eyes.
Normal
Advertisement
Table of Contents
