Panasonic PT-LRZ35 Operating Instructions Manual page 59

f The items will switch each time you press the button.
[Low]
[Standard]
[High]
Note
f [Color Temperature] is grayed out if the [Image Settings] menu → [Picture Mode] is set to [Natural], [Rec709], [DICOM SIM.], [Dynamic] or
[3D].
Setting with [Color Space]
The projector will automatically detect the input signal, but you can set the system format manually when an
unstable signal is input. Set the system format matching the input signal.
1) Press as to select [Color Settings].
2) Press w or the <ENTER> button.
3) Press as to select [Color Space].
4) Press w or the <ENTER> button.
f The [Color Space] screen is displayed.
5) Press qw to to switch the item.
f The items will switch each time you press the button.
[Auto]
*1
[RGB]
*2
[YPBPR/YCBCR]
*3
*1 Only for HDMI signals
*2 Only for RGB signals
*3 Only for YP P /YC C
B R B R
Note
f [Color Space] is hidden if a NTSC/PAL/SECAM signal is input.
f For details of the image signals that can be used with the projector, refer to "List of compatible signals" (x page 104).
f This may not operate properly for some connected external devices.
[Signal]
(Only for COMPUTER 1 IN and COMPUTER 2 IN input)
Adjust the signal synchronization settings for COMPUTER / Component sources.
1) Press as to select [Signal].
2) Press w or the <ENTER> button.
3) Press as to switch the item.
f The items will switch each time you press the button.
[Automatic]
[Dot Clock]
[Phase]
[H. Position]
[V. Position]
Chapter 4 Settings - [Picture] menu
Becomes a reddish image. Select this when the white areas of the projected image are bluish.
Becomes an image with standard color.
Becomes a bluish image. Select this when the white areas of the projected image are reddish.
The color matrix type is selected automatically according to the input signal.
Select an appropriate color matrix type.
signals
[On] Configure the signal automatically.
[Dot Clock], [Phase], [H. Position] and [V. Position] will be available for tuning and
[Off]
saving the settings.
Use this function to adjust the dot clock and minimize the effect of interference caused by
projection of patterns consisting of vertical stripes.
Adjusts to achieve an optimal image when there is a flickering image or smeared outlines.
Adjusts the image position if the image projected on the screen is shifted left or right even when
the positions of the projector and screen are correct.
Adjusts the image position if the image projected on the screen is shifted up or down even when
the positions of the projector and screen are correct.
ENGLISH - 59