Selectable polarity assignment for the audio input connector:
◦
Pos: Positive pressure on microphone diaphragm produces positive voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output on the receiver.
◦
Neg: Positive pressure on microphone diaphragm produces negative voltage on pin 2 (with respect to pin 3 of XLR output)
and the tip of the TRS output on the receiver.
Offset
Adjust Offset level to balance mic levels when using two transmitters or when assigning multiple transmitters to receiver
slots. Adjustment range: -12 dB to +21 dB.
Tone Gen
Tone generator. Transmitter will generate a continuous test tone:
◦
Freq: The tone can be set to 400 Hz or 1000 Hz.
◦
Level: Adjusts the output level of the test tone.
Utilities Menu
Device ID
Assign a device ID of up to 8 characters.
Locks
Locks the transmitter controls and power switch.
◦
None: The controls are unlocked
◦
Power: The power switch is locked
◦
Menu: The menu parameters are locked
◦
All: The power switch and menu parameters are locked
Marker
When enabled, press O to drop a marker in Wireless Workbench.
Battery
Displays battery information:
◦
Battery Life: Runtime reported in bar display and time (hours:minutes)
◦
Battery Time to Full (only appears when Shure rechargeable battery is being externally charged): Time remaining until bat
tery is fully charged
◦
Charge: Percentage of charge capacity
◦
Health: Percentage of current battery health
◦
Cycle Count: Total of the number of charging cycles for the installed battery
◦
Temperature: Battery temperature reported in Celsius and Fahrenheit
About
Displays the following transmitter information:
◦
Model: Displays the model number
◦
Band: Displays the tuning band of the transmitter
◦
FW Version: Installed firmware
◦
HW Version: Hardware version
Shure Incorporated
16/23