Group No. (Available For Multiplexed Remote Master/Sub-Master Station Only); Mode - Mitsubishi Electric MELSEC Q Series Reference Manual

5 PARAMETER SETTINGS
Selection item
Online
(Default)
Offline
Forward loop test
Reverse loop test
5 - 7
(4) Group No. (available for multiplexed remote master/sub-master
station only)
Set the group No. to send data simultaneously to other stations in transient
transmission.
(a) Valid setting range
0 : No group specification (default)
1 to 32 : Group No.

(5) Mode

Set the operation mode of the network module.
The mode selection with this parameter becomes valid when the mode setting
switch of the network module is set to 0 or 4.
This mode performs normal operations (the station returns to the network).
Starts data communication at startup and executes automatic return operation. etc.
This mode stops operations (disconnecting the station).
Baton pass and data communication with other stations are not executed.
This mode is to select the hardware test operation that checks the connection status
and the optical fiber cables on the forward loop side. (Remote master station only)
For details on how to conduct the hardware test, refer to Section 4.9.1.
This mode is to select the hardware test operation that checks the connection status
and the optical fiber cable on the reverse loop side. (Remote master station only)
For details on how to conduct the hardware test, refer to Section 4.9.1.
Description
MELSEC-Q
5 - 7