B Trim Options For Rhedv32 - Vermont Castings RHEDV25 Installation Instructions & Homeowner's Manual

Vermont Castings, Majestic Products RHEDV Direct Vent Insert
A4 Riser Kits
For use with RHEDV25 (Refer to Page 34, Figure 55)
1. Install the unit according to Homeowner's Manual.
2. Install the trim according to Installation Instructions.
3. Remove the two (2) screws at the bottom of the
trim.
4. Install the riser at the bottom of the trim. (Fig. 55)
5. Fasten the trim with the same two (2) screws
removed on step 3.
Riser Trim Dimensions
Length - A
RHE25R1-Riser 1" 38.3" (973mm) 1" (25.6mm) 2.86" (72.8mm)
RHE25R-2Riser 2" 38.3" (973mm) 2" (50.9mm) 2.89" (73.6mm)
RHE25R5-Riser 5" 38.3" (973mm) 5" (127.9mm) 2.86" (72.8mm)

B Trim Options for RHEDV32

B1 RHESS, RHESL, RHESSD, RHESLD, &
RHESXL Trims
For use with RHEDV32
Frame Assembly
RHESS, RHESL, RHESSD, RHESLD and RHESXL
1. Lay Trim Top Facing and Trim Side Facings, face
down on to an even surface such as a table or floor.
Be sure not to scratch the painted surfaces.
2. Install the nuts and bolts. (Fig. 38)
Rear View
Frame Top
Left
Frame
Fig. 38 Attach left and right frame to frame top.
Trim Assembly
RHESS, RHESL and RHESXL (Fig. 39)
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the
back side.
26
Height - B Depth - C
10/24 Screws
10/24
Nuts
Right Frame
FP1259
3. Install the trim top deflector and use two screws to
fasten it. (Fig. 39 & 40)
4. Remove ALL plastic protective covering from brass
trim.
Trim Top
Channel
Trim
Side
Channel
Screw
Fig. 39 Install trim channels and trim top deflector.
Side View
Trim Top Deflector
FP1261a
Fig. 40 Trim top deflector.
RHESSD and RHESLD (Fig. 41)
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Peel off plastic protective covering from top edges of
the inner sides where they will be covered by the
inner top trim facing.
3. Place the trim facing inner top in place (do not fasten
it yet). Peel off the plastic protective covering from
the bottom edge.
4. Install the trim top deflector and fasten it (will hold
the inner top piece). Use two screws to assemble
them.
5. Install trim channels (left and right sides). Use two
screws to assemble each piece.
6. Slide on the trim top channel and fasten it from the
back side.
7. Remove ALL plastic protective covering from brass
trim.
Trim
Side
Channel
Deflector
Trim Top
FP1260
Trim Frame Top
Section
10000801