Ceramic Refractory Installation - Vermont Castings RHEDV25 Installation Instructions & Homeowner's Manual

Flue Collar
Plate
FP1281
Fig. 10 Remove flue collar plate assembly.
Damper
Unit
Fig. 11 Apply high temperature sealant to end of collar.
Damper
Front
Frame
Unit
Fig. 12 Fasten with two clamps, adjust fastener plate all the
way back.
3. After the flue collar plate is set on the cabinet top,
make sure the front edge of the flue collar plate is
completely in contact with the back edge of the
cabinet top. (Fig. 13)
4. Put the machine screw back into the fastener plate.
Bolt the plate until it is locked. (Fig. 14)
NOTE: Insulation can be installed above the damper
area only, provided the insulation material is of
noncombustible type.
Under no circumstances should
insulation be put between the damper
and the top of the unit. This may cause
condensation and overheating of the unit.
10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
Fastener
Plate
Move
Cabinet
Back
Top
10/24" x 1 "
Machine Screw
3" Flex Vent
Two Pieces
Clamps &
Screw
Fastener
Plate
Gasket
FP1282
3" Chimney
Liner Two
Pieces
Clamps &
Screw
Flue Collar
Plate
FP1283
Flue Collar
Plate
FP1284
Fig. 13 The flue collar plate must be completely in contact
with back edge of cabinet top.
Plate Flue
Collar
FP1285
Fig. 14 Use machine screw to bolt fastener plate in place.

Ceramic Refractory Installation

1. Remove front glass.
2. Remove logs from unit.
3. Remove refractory from package
Refractory are fragile and must be han-
dled with care. Where at all possible, two
hands should be used when handling.
4. Take center refractory and tilt so bottom edge slides
into support angle in back of fireplace. (Fig. 20)
5. Now press center refractory to back side of fireplace
and hold in place.
6. Take left or right refractory and align it so leading
edge faces outward. (Place refractory in fireplace
side and slide it forward into side support angle on
fireplace front. Leading edge of refractory must be
completely behind side support angle of RHEDV32
for proper placement).
7. Now carefully slide in back side of refractory against
fireplace side.
8. Repeat steps 6 and 7 for remaining side refractory.
When side refractory is installed cor-
rectly, the center refractory will be sup-
ported by the side refractory.
Left Side
Center
Leading
Edge
Fig. 15 Ceramic refractory.
Fastener
Plate
Cabinet
Top
Make sure the flue collar
plate is in contact with the
back edge of the cabinet top
Fastener Plate
Cabinet
Top
Machine Screw
After Fastened
Right Side
Leading
Edge
Bottom
Edge
FP1287
9