Replacing Rear Light; System); Replacing Rear Lamp Holder; Lighting System) - Invacare Kite Series Service Manual

Installing Rear Bulb
1. Install glass and tighten the Phillips screw finger-tight.
2. Test all functions.
6.12.8 Replacing Rear Light (Conventional Lighting System)
• 8 mm socket wrench
Removing Rear Light
1. Turn off electronics on remote.
2. Remove rear shroud. See 6.6 Shrouds, page 21.
3. Take exact note of positions of all cables and sockets that they are connected to. Mark connectors and sockets or
take a photograph with a digital camera.
4.
Disconnect cable of rear light from lighting circuit board.
5. Remove both covering caps (6).
6. Loosen four nuts (5).
7. Remove nuts and washers (4).
8. Pull rear light (1) towards rear and remove both bushings (3) including lamp protector (2).
Installing Rear Light
1. Install parts in reverse order.
2. Tighten screws hand-tight.
3. Test all functions.
6.12.9 Replacing Rear Lamp Holder (Conventional Lighting System)
• Size 2 Phillips screwdriver
• 8 mm socket wrench
• 4 mm Allen wrench
• 5 mm Allen wrench
Removing Rear Lamp Holder
1. Remove rear light.
2. Loosen screw on seat frame that goes through drill hole of light bracket.
3. Remove screw. Pay attention to the distance washer (5).
1552415-K
Fig. 6-66
Fig. 6-67
Service
57