Replacing Castor Wheels On Single-Sided Fork - Invacare Kite Series Service Manual

Installing Wheel
1. Install parts in reverse order.
2. When installing wheel, pay attention to correct direction of rotation.
3. Tighten nut to prescribed torque. See 6.9.3 Specific Tightening Torques, page 34.

6.9.8 Replacing Castor Wheels on Single-Sided Fork

• 24 mm wrench
• Oblong wooden block (at least 14 x 14 x 30 cm)
Removing Wheel
1. Place wooden block underneath mobility device and prop up mobility device.
2. Remove end-caps from bolt and nut (if applicable).
3. Remove nut and washer from bolt.
4. Remove bolt and wheel from fork.
Installing Wheel
1. Install parts in reverse order.
2. When installing wheel, pay attention to correct direction of rotation.
3. Tighten nut to prescribed torque. See 6.9.3 Specific Tightening Torques, page 34.
Replacing Castor Wheel (AVIVA RX, TDX SP2)
• TX30 Torx key (TDX SP2)
• TX40 Torx key (AVIVA RX)
• Oblong wooden block (at least 14 x 14 x 30 cm)
Removing Wheel
1. Loosen and remove screw (3) including washer (1).
2. Remove castor.
3. Replace castor.
Installing Wheel
1. Install parts in reverse order.
2. When installing wheel, pay attention to correct direction of rotation.
3. Tighten screw (3).
1552415-K
Fig. 6-38
Service
41