Table of Contents
Advertisement
S
ETUP
Installing or Replacing SAM Cards
Front Functions
Back Functions
Installing or
Replacing SAM
Cards
CAUTION
To install or replace
SAM cards
12
QX700 I
NSTALLATION
The front of the contactless device shows the following:
•
Customer-view indicator LED.
•
A contactless reader panel.
The rear of the contactless device shows the RS-232 connector.
You may need to install a security access module (SAM) card or replace the old
card.
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. VeriFone recommends
using a grounded anti-static wrist strap.
1
Disconnect the device from any external devices.
2
Place the reader face down on a soft, clean surface to protect from scratches.
3
Using a Phillips head screwdriver, unscrew and remove the back casing to
access the SAM card holder.
Figure 3
Removing QX700 Back Casing
4
Open the SAM cardholder, by sliding the locking tab to the
5
Carefully slide the SAM card into the slot, by aligning the card and carefully
sliding into the slot until fully inserted.
G
UIDE
position.
OPEN
Advertisement
Table of Contents
