Assembling Dust Chute; Electrical Connections - Delta RC-51 Instruction Manual

ASSE MBLING
D UST CHUTE
To assemble the dust chute to your planer, remove the
three screws (A) Fig. 5, from the rear of the planer. The
dust chute is then assembled to the rear of the planer,
as shown in Fig. 6, and fastened in place using the three
screws (A) Fig. 5.
ELECTRICAL
CONNECTIONS
Before con necting your machine to an electrical power
system, make sure the motor ratin g agrees with the elec­
trical system it is to be con nected to. The single phase
planer is shipped wired for 230 volts only and the three
phase planer is shipped wired for
volts was specified. In all cases remove the black terminal
strip cover (A) Fig. located on the rear of the machine.
7,
Bring the power line up through the connector located on
bottom of the terminal strip cover and proceed as follows:
If single phase, con nect the two power lines to terminals
L 1 and L2 and the green ground line to the ground
terminal, as shown in Fig.
If three phase, con nect the three power lines to terminals
L 1, L2 and L3 and the green ground line to the ground
terminal, as shown in Fig. 9. IMPORTANT - THREE
PHASE MACHINE ONLY. If after the machine is in opera­
tion the cutterhead revolves in the wron g rotation, simply
interchange any two of the three power lines that are
connected to terminals L 1, L2 and L3.
'
230 volts unless 460
8.
5
Fig. 5
l2
Fig. 8