Delta RC-51 Instruction Manual page 15

4.
With a feeler gage (D) Fig.
tween the table surface and the straight edge (8) near the
infeed roll (E).
5.
If an adjustment to the infeed roller (E) Fig.
necessary, loosen set screw (F) Fig.
neath the left front end of the table.
6.
Turn adjustme n t collar
needed to attain proper height adjustment.
7.
Tighten set screw (F) Fig.
made.
To check the outfeed roller height setting, proceed as
follows:
1.
With a feeler gage (H) Fig.
tween the table surface and the straight edge (8) near the
(J).
outfeed roller
2.
If an adjustment to the outfeed roller is necessary,
39,
loosen jam nut (K) Fig.
machine under the table, and turn collar (L) right or left
as needed until the outfeed roller is adjusted properly.
3.
Tighten jam nut (K) Fig.
36,
measure the gap be­
36,
37,
located under­
(G) 37,
Fig. left or right as
37,
after adjustment is
38,
measure the gap be­
located on the left side of
39.
is
15
36
Fig.
37
Fig.
38
Fig.
39
Fig.